Australia Wide Shipping
Australia Wide Shipping
$700.00 – $1,300.00 inc GST
Skiafloor 94 is a low viscosity, solvent free epoxy Primer and general purpose Binder resin. Sikafloor 94 is a two component, low viscosity, 100% Solid Epoxy Primer and Binder resin system.
Sikafloor®-94 is a two component, low viscosity, 100% Solid Epoxy Primer and Binder resin system
Yellowish transparent
Available in proportioned 30 kg
Part A+B
Part A Part B = 2 :1 (by Mass and Volume)
Application range recommended +5 to +30 Degrees C
10 Degrees C – 30 mins.
20 Degrees C – 20 mins.
10 degrees C 15 hours
20 degrees C 8 hours
Note: Waiting times are approximately halved with the addition of Sikafloor Booster
Primer
CSP 2-3 profile 5-6m2 L approx.
CSP 4-5 profile 2-3m2 L approx.
Mortar
Range of 1:5 to 1:8 mixed litre of Sikafloor®-94 to kg blended silica sands
Part A and B to be mixed the correct ratio for a minimum of 2 minutes
Primer
Roll product evenly on and into the surface.
If the product is completely absorbed then an additional coat should be applied within 24 hours.
Mortar
When used as a binder in Profiling screeds or Coving mixes, the substrate should also be primed with Sikafloor®-94
PDS | SDS Part A | SDS Part B
Colour accuracy disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.
Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.
James Carroll –
We were recommended to use this product and have applied to our old dusty floor and it has done a magic and seal it perfectly
Sean Berang –
An excellent epoxy primer!
Michael Wilson –
The best primer for big floors. Levels very smoothly. Thank SIC for their directions on its usage. Very friendly staff.
Ronald Petrovic –
Loved this product. I think it’s one of the best ones.
Edris Samuel –
good product but expensive