Australia Wide Shipping

Placeholder

Sikagard 62T – 24kg Kit

$650.00 inc GST

Ultra high build chemically resistant coating / lining

Quantity:
SKU: 126F49 Categories: ,

Sikagard 62T Part A+B 24kg Kit Grey (MTO)

Sikagard®-62 T is a trowelable/sprayable ultra high build lining for harsh environments.

 

Reviews

There are no reviews yet.

Be the first to review “Sikagard 62T – 24kg Kit”

Your email address will not be published. Required fields are marked *

USES

Sikagard®-62 T is used as a protective lining for:

  • Chemical bunds area
  • Waste Water Treatment and Holding Facilities
  • Storm Water Pits
  • Drinking Water Facilities

CHARACTERISTICS AND ADVANTAGES

  • Protective and decorative.
  • Excellent chemical resistance.
  • Easy for cleaning and graffiti removal.
  • High abrasion resistance.
  • Excellent adhesion to  most building materials.
  • Can be built up to 5mm per pass.
  • Approved for use with potable water.
  • Can be spray applied.

Grey

Part A 18 kg
Part B   6 kg

SUBSTRATE QUALITY

The substrate must be sound, clean, dry, free from contaminants such as dirt, grease, oil, old coatings, release agents, laitance and other adhesion preventing or influencing substances. On high absorbent, non-sound, contaminated, not cement based substrates precautions have to be taken and a suitable primer has to be used.

SUBSTRATE PREPARATION

Concrete Substrates
Concrete substrate must be prepared mechanically to achieve an open textured surface. Weak areas in the substrate must be removed and
surface defects such as blowholes and voids must be fully exposed. All dust, loose and friable material must be completely removed from all surfaces before application of the product, preferably by brush and/or vacuum. Open voids and blowholes need to be closed with a suitable Sika® pore filling mortar. The roughness of the substrate needs to be levelled with a suitable Sika® rendering and levelling mortar.

Steel Surface
Steel surface must be prepared mechanically using abrasive blast cleaning. The level SSPC-SP 10 “near white metal blast cleaned” or level Sa 2 ½ according to ISO EN 12944-4 has to be achieved. Welds and joints have to be prepared according to EN 14879, part 1. After blast cleaning remove all dust dirt and blasting material. In order to maintain the surface conditions after blast cleaning air-conditioning is recommended.

MIXING

Prior to mixing stir part A mechanically. When all of part B has been added to part A mix continuously for 3 minutes until a uniform mix has been achieved. Use a low speed electrical stirrer (300–400 rpm) to avoid air entrapment. To ensure proper mixing pour material into a clean container and stir again.

APPLICATION

Apply by brush, roller or airless spray.

Part B-SDS | Part A-SDSPDS

https://aus.sika.com/en/construction/concrete-repair-protection/corrosion-management/corrosion-inhibitors/sikagard-62-t.html

Colour accuracy disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.

Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.

Google Rating
5.0
Based on 78 reviews
×
js_loader