Australia Wide Shipping

Screenshot 2023-01-18 221847Screenshot 2023-01-18 221847

Sika MonoTop 910N – 10kg

$75.00 inc GST

Bonding Primer and Reinforcement Corrosion Protection

 

Quantity:
SKU: 953D16 Categories: ,

Sika® MonoTop®-910 N is a cementitious, polymer modified one-component coating material containing silica fume used as bonding primer and reinforcement corrosion protection for reinforcement. Sika® MonoTop®-910 N meets the requirement of EN 1504-7

Reviews

There are no reviews yet.

Be the first to review “Sika MonoTop 910N – 10kg”

Your email address will not be published. Required fields are marked *

USES

  • Suitable for control of anodic areas (Principle 11, method 11.1 of EN 1504-9)
  • Suitable as a bonding primer on concrete and mortar
  • Suitable in concrete repair as reinforcement corrosion protection

 

CHARACTERISTICS AND ADVANTAGES

  • CE certified to EN 1504-7
  • Easy to mix, just add water
  • User-friendly application
  • Excellent adhesion to concrete and steel
  • Good resistance to water and chloride penetration
  • Good mechanical strengths
  • Can be brushed on or applied using spray gun

Grey Powder

5kg pails and 20 kg bags

MIXING

Sika MonoTop®-910 N can be mixed with a low speed (<500 rpm) electric drill mixer. In small quantity, Sika MonoTop®-910 N can also be mixed by volume in a mixing ratio of 4 part of powder by 1 part of water.
Pour the water in the correct proportion into a suitable mixing container. While stirring slowly, add the powder to the water. Mixed thoroughly to the required consistency (brushable non-dripping consistency).

APPLICATION

As a bonding primer
Apply by brush, roller or suitable spraying equipment to the prepared (pre-wetted) substrate. To achieve good bond, Sika® MonoTop®-910 N must be applied well into the substrate, filling all unevenness.
Subsequent repair mortar must be applied while the bonding primer is still wet.
As reinforcement protection
Apply first layer approx. 1.0 mm thick, using medium hard brush or spray gun to cleaned reinforcement. When first coat is hard to the finger nail, for guidance~4 to 5 hours at 20°C, apply second layer approximately 1.0 mm thick.

CURING TREATMENT

As reinforcement corrosion protection – protect the fresh mortar immediately from premature drying and contamination using an appropriate curing method.

Safety Data Sheet (SDS) | Product Data Sheet (PDS)

https://aus.sika.com/en/construction/concrete-repair-protection/concrete-protection/sika-monotop-910n.html

Colour accuracy disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.

Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.

Google Rating
5.0
Based on 78 reviews
×
js_loader